16
(4) FENDERS, TOOLBOX, CENTER FRAME
① Remove the fenders and ROPS. frame: lower.
② Remove the clip pin and pin from the both brake levers
to separate the hand brake wires.
③ Remove the center frame.
(5) TRANSMISSION COVER PLATE
① Remove the transmission cover：Flower.
(6) CASE COVER BRAKE ROD
① Remove the bolt, banjo bolt and return pipe from the
clutch housing. transmission housing (HST Model
only).
② Remove the step plates, from both sides of the tractor,
see ENGINE REMOVAL.
③ Remove the case cover.
④ Place blocking at the front and rear of both front wheels.
⑤ Disconnect the brake rods from the brake lever.
031Y
032Y
033Y
To Next Page
Loading...
