83
7） Drive shaft (4WD)
Drive out the drive shaft (4WD) front-wards and
remove the slide gear.
1. Drive shaft
2. Slide gear
3. Bearing (6303)
8） Shifter rod・Shifter fork (4WD)
① Drive out the shifter rod rear-wards and remove
the shifter fork.
NOTE：
When the shifter rod pulled out, a steel ball and spring
come out from in the shifter fork.
Be careful not to miss them.
② Drive out the spring pin and remove the change
lever.
③ Remove the shift arm from the inside of the
housing.
9） Drive Shaft・Retainer・Oil seal
（Remove it from clutch housing）
① Remove the snap ring (φ30) and take out the
fixed gear from drive shaft.
② Remove the snap ring (φ52) from in the retainer
and drive out the drive shaft and bearing to
rear-ward.
③ Remove bolts and retainer from rear of clutch
housing.
④ If necessary remove the oil seal from in the
retainer and clutch housing.
350Y
351Y
352Y
To Next Page
Loading...
