General technical data
Hardware - SIMADYN D 1-5
Edition 08.2005
1
1.1.4 Machinery Directive
In accordance with the Machinery Directive 89/392/EC, it should be
ensured that if SIMADYN D fails or executes an incorrect function, that
this does not result in the machine/system going into a potentially
hazardous condition. This must always be taken into account when
configuring the machine/system.
The system may not be commissioned until it has been proven that the
final product is in conformance with the Directive.
The Low-Voltage Directive 73/23/EC is only applicable for products with
supply voltages of ≥ 50 V AC and/or > 75V DC.
For SIMADYN D, this involves the following components:
• SP 7 6DD 1683-0BB0
• SP 8.5 6DD 1683-0BC0
• SP 9.5 6DD 1683-0BE5
• SP 22.5 6DD 1683-0CC5
• SP 23.5 6DD 1683-0CD5
• SB 60 6DD 1681-0AF4
• SB 70 6DD 1681-0AG2
• SRT 400 6DD 1662-0CG0
These components correspond to the requirements of the Low-Voltage
Directive.
!
WARNING Open equipment
SIMADYN D is regarded as open equipment. This means that you
must always install SIMADYN D in a cubicle, cabinet or electrical
control room that can only be accessed using a key or tool. Only
trained or authorized personnel are allowed access to such
cubicles, cabinets or electrical operating rooms.
1.1.4.1 SIMADYN D outputs
!
DANGER When the equipment is powered-up or powered -on, the outputs
have undefined statuses while the power supply voltages are
running-up. This fact must be taken into account when designing
the system.
Low-Voltage
Directive
To Next Page
Loading...
