Operator control panel OP2
10-8 Hardware - SIMADYN D
Edition 03.2001
Possible message formats
Prefix/suffix Text Evaluation and display on the OP2
no no Message is not administered.
yes no The prefix is evaluated as message class. If the
message class is permissible, the message is
administered (stored) in the prefix/suffix format.
no yes Messages without prefix/suffix, with text, are always
administered in the OP2.
yes yes Prefix is evaluated as message class. If it is valid, the
message is administered (stored) in the text format.
If process data (with dimensions) is included in a message, then the OP2
„cuts“ the message text after 28 characters if it is longer (independent as to
whether a dimension is available or not). The message text may be up to 56
characters long if there is no process data.
If the message text is shorter than the maximum length, then the remaining
characters are filled with „blanks“; i. e. the display stays „dark“ at these
positions. Thus, the following message format is provided at the display
(2x40 characters) (d=day, m=month or minutes, y=year, h=hours,
z=milliseconds, T=message type (warning, fault etc.):
1) Message with process data (and dimension): Max. 28 message
characters
dd.mm.yy hh:mm:ss.zzz T A MAX. OF
28 CHARACTERS ARE HERE!!-999.12345678 E+99
DIMENSION
2) Message without process data: Max. 56 message characters
dd.mm.yy hh:mm:ss.zzz T A MAX. OF
56 CHARACTERS COME FROM SIMADYN D!!!!
Example for a message in the ASCII text format with measured value
(without dimension):
01.10.94 00:00:05:167 W THE MOTOR RUNS
WITH UE CURRENT -99999.1234567 E+99
For the „prefix/suffix“ format, the following message formats can be
displayed on the OP2 display (d=day, m=month or minute, y=year, h=hour,
z=milliseconds, T=message type (warning, fault etc.):
1) Message with process data (and dimension):
dd.mm.yy hh:mm:ss.zzz T P:54321 S:54321
-999.12345678 E+99 DIMENSION
2) Message without process data:
dd.mm.yy hh:mm:ss.zzz T P54321 S:54321
10.3.3 Message print-out
The OP2 defines the message format at the printer, so that 2 display lines (i.
e. a complete message) are combined to form a printer line. OP2
automatically inserts a line break after each message. A message is
therefore always 80 characters long; the character length at the printer
should be appropriately set. OP2 does not change the message structure.
ASCII text message
Prefix/suffix
message
To Next Page
Loading...
Need help?
General
