Siemens SIMATIC ET 200S - Address area for option handling and status byte

Address Space of the Input and Outputs of the ET 200S
C-2
ET 200S Distributed I/O System
EWA-4NEB 780602402-12
Table C-1 Inputs and outputs for the ET 200S, Fortsetzung
Module Address space of the
outputs
Address space of the
inputs
Module
With
grouping
1)
Without
grouping
With
grouping
1)
Without
grouping
4 IQ-SENSE (standard) 1bytes -- -- -- -- -- --
4 IQ-SENSE (Enhanced) 4bytes 4bytes
ET 200S FC frequency
converter
8bytes 8bytes
1)
See Section 6.1.1 (Configuring the ET 200S on the PROFIBUS DP)
2)
Additional optional entries you can select from the DBB file
Address area for option handling and status byte
You can control and monitor option handling, and evaluate the status byte of the
power module using the control (PIQ) and feedback interface (PII).
The address range of the control (PIQ) and feedback interface (PII) depends on
the configuration or selection of the corresponding entry in the configuration
software.
In STEP 7, HWCONFIG
or COM PROFIBUS or
other configuration
software
Control interface
(PIQ)
Feedback interface (PII)
Usual entry for the
Power module
Ends in ...S
Ends in ...O
Ends in ...SO
ABx
:
ABx+7
Option
handling
ABx
:
ABx+7
Option
handling
ABx+8
Not applicable
-- -- --
EBx
:
EBx+7
Option
handling
EBx
Status Byte
EBx
:
EBx+7
Option
handling
EBx+8
Status Byte
-- -- --
-- -- --