Siemens SIMATIC ET 200S - Option handling in PIQ;PII; Status byte power modules

Address Space of the Input and Outputs of the ET 200S
C-3
ET 200S Distributed I/O System
EWA-4NEB 780602402-12
Option handling in PIQ/PII
Bit no.
QB/IB x
QB/IB x+1
713654
2
0
QB/IB x+2
QB/IB x+3
QB/IB x+4
QB/IB x+5
QB/IB x+6
QB/IB x+7
7
1365
42
*
815 1314 1112 10 9
18
1920
23
22 21 17
28
16
36
27293031 24
34
35
26 25
39
323738
47
33
4146 40
4950
4345
44
42
53 5254 4855
61
51
58
62 59
60
5763 56
PIQ: AB x to AB x+7
PII::EBxtoEBx+7
* Not applicable
Slots 2 to 63 0: Parameter assignment for option handling applies.
RESERVE modules are permitted:
• The station is engaged in data transfer.
• A diagnosis is not reported.
• The SF LED on the interface module is off.
1: Parameter assignment for option handling is
cancelled. RESERVE modules are not accepted on
this slot:
• The station is engaged in data transfer.
• The diagnosis ”Incorrect module” is reported.
• The SF LED lights up on the interface module
Slots 1 to 63 0:
The RESERVE module or an incorrect module is on
the slot or a module has been removed.
1:
The configured module is on the slot.
Status byte power modules
Bit no.
IB x+8
713654
2
0
000
0: load voltage present
1: no load voltage
1: Sensor or load voltage is missing
(present in all PM-E power modules)
1: defective fuse (only in the case of the PM-E 24--48
VDC/120--230 VAC)
Diagnostic bits of the
power modules