Siemens Sinumerik 840DiE sl - Page 248

01/2007
9.2 ONLINE commissioning
9-248
© Siemens AG 2007 All Rights Reserved
SINUMERIK 840Di sl Manual (HBIsl) -- 01/2007 Edition
Perform the following actions:
1. To create the online connection, select the corresponding drive unit in the
project navigator (1) and click the ”Connect to target system” button (2).
Project
Add individual drive
Drive_Unit_Addr10
STARTER -- Project
Project Edi t Target System V iew Tools Window Help
2
1
2. After the online connection to the drive unit has been established, click but-
ton: ”Restore factory settings”.
Project
Add individual drive
Drive_Unit_Addr10
STARTER -- Project
Project Edi t Target System V iew Tools Window Help
Confirm the following dialog with OK to restore the factory settings.
3. Double--click ”Automatic configuration” in the project navigator.
The navigator then searches for all components connected to the drive unit
and loads these into the STARTER.
Proje
ct
Add i ndividual drive
Drive_Unit_Addr10
Topology
Overview
Automatic configuration
Configuration
Overview
STARTER -- Project
Project Edi t Target System V iew Tools Window Help
-- In the following dialog box: ”Automatic configuration” click the button:
”Start automatic configuration”.
-- In the following dialog box: ”Drive object type” select the type: ”Servo”
and click the button: ”Finish”.
Execution
9
D
r
i
v
eComm
i
s
s
i
on
i
n
g
(
SI
N
A
MICS
)