Snap-On Zeus - Snap-On Cloud - New User Registration

The Snap-on® Cloud Registration - Getting Started
204
17.3.1 Snap-on Cloud - New User Registration
z If you are a new user, follow these steps to register and create a new
account:
NOTE
If you are a Shop Key Pro or SureTrack user, see Snap-on Cloud - ShopKey
Pro or SureTrack User Setup on page 205.
1. Connect the diagnostic tool to a Wi-Fi network, see Wi-Fi Setup on page 13.
2. From the Home screen, select System Settings > Get Connected, and write
down the Serial Number, PIN and Code that are displayed (Figure 17-1).
Figure 17-1
NOTE
The PIN and Code numbers will change each time you view the Get
Connected screen (Figure 17-1). This is normal, any displayed set of PIN and
Code numbers may be used to register.
3. Select the weblink (Figure 17-1) to open the Login page.
4. Select Create Individual Account.
5. Enter the required information and create a Username and Password, then
select Create.
6. At the “Success” confirmation screen, select Done.
7. Log in using your Username and Password.
8. Answer the security questions, then select Submit.
9. From Technician Profile Manager select the Device Management tab.
10.Select Add Device, then enter your Serial Number, PIN, Code, and Device
Name and select Save when done.
11. Log out of Profile Manager and close the window.
12.Turn the diagnostic tool off, and then on (reboot).
13.To login and use the Snap-on Cloud, see Using the Snap-on Cloud on
page 206.
Your diagnostic tool is now registered to your Snap-on Cloud online account. Files
will be automatically sent (only when connected to Wi-Fi) to your online account from
the device.
NOTE
If the device is not connected to a Wi-Fi network, files will not be sent to your
Snap-on Cloud account. Wi-Fi connection is required to upload files to
the Snap-on Cloud.
Device details...
Serial Number: XXXXXXXXXXXXX
PIN Code: XXXXXXX
Activation Code: XXXXXXXXX