Sony XVS Series

188
• “Main&Sub” and “Sub” are added to the macro event
configuration parameters and macro attachment settings.
• “Sub Program,” “Sub Preset,” and “Sub Trans PGM” on
each switcher bank are added to the link source bus for
cross-point button link settings.
• Snapshot attributes can be set independently for main
and sub.
• Menus for the sub bank are added to menus that can be
recalled by pressing a button twice.
• [MP2 Auto Correct] settings are available in the Effect
menu or Snapshot menu. For example, enabling this
determines whether the copy destination and copy
source data is the main bank or sub bank, and
automatically switches the data.
• The [SUB TRANS] button on the key control block is
enabled. This functions as the [TRANS] button for the
sub bank.
• You can display whether key 1 to key 8 are assigned to
the main bank or the sub bank in the display of the
transition control block.
• On the cross-point pad of the cross-point control block,
cross-point hold of the utility 3 bus can be set.
Also, main and sub information is displayed on the
switcher bank display buttons.
• The [MAIN] button and [SUB] button are enabled on the
transition control block and transition control block
(simple type).
Differences Between Multi Program 2 Mode and Standard Mode
The differences from operation in standard mode are as
follows.
a) Key 2 to key 8 are common on both main and sub.
Item Main Sub
Keys
a)
Key 1 to key 8 can be used Key 2 to key 8 only can be used
Wipes
(background)
Patterns Same as standard mode • Only standard wipe patterns can be
used
• Pattern mix cannot be used
Modifiers Same as standard mode • Split, pairing, modulation, spring, and
spiral cannot be used
• Edge fill mattes are single color only
• Four types of multi replication are
available for selection.
Wipes
(keys)
Patterns • Only standard wipe patterns can be used
• Pattern mix cannot be used
Modifiers • Split, pairing, modulation, spring, and spiral cannot be used
• Edge fill mattes are single color only
• Four types of multi replication are available for selection.
DME wipes Use Supported Cannot be used (Can be used, with a
setting change)
Patterns for 1 channel Main and sub can be used separately.
Patterns for 2 channels Only one of main and sub can be used.
For each M/E, the number of DMEs that can be used is the same as in
standard mode.
Patterns for 3 channels
Backgrounds Wipe edge fill matte (including
color mix and other settings in the
Matte Adjust menu)
Wipe edge fill matte (single color only)
Modifiers Same as standard mode Wipe border colors are single color only
Transitions Key priority Not supported
Transition preview Not supported
Preset color mix Color matte or video signal
selected on the utility 2 bus
Color matte only
Snapshots Cross-point hold Utility 2 cannot be set • Utility 3 is added.
• BKGD A/B and Key1 cannot be set.