416
6
Select the M/E or PGM/PST link destination, then
press [M/E Set].
To also link operations other than transition
execution
Press [Transition Only], turning it off.
To release the link
Select the link number and press [Clear].
Setting Key Transition Links
The operations which can be linked are as follows.
• Auto transition
• Key on/off
1
In the Engineering Setup >Switcher >Link menu
(7336), press [Key Trans Link].
The Key Transition Link menu (7336.7) appears.
2
Select the target link number to set.
3
In the <Key Select> group, select [Master Key] (link
source).
4
Select the key for the link source, and press [Key Set].
5
In the <Key Select> group, select [Linked Key] (link
destination).
6
Select the key for the link destination, and press [Key
Set].
To release the link
Select the link number and press [Clear].
Settings Relating to
Device Connections
Assigning an AUX Bus to Ext In on a
DME
You can set the signal (AUX bus output) that is input on
Ext In on a DME.
1
In the Engineering Setup >Switcher >Device Interface
menu (7337), press [DME Interface].
The DME Interface menu (7337.7) appears.
2
In the list on the left, select Ext In on the target DME
channel to set.
3
In the list on the right, select the AUX bus to assign to
Ext In.
To Next Page
Loading...
