303
To select all regions, press [ALL]. To select all
switcher-related regions (M/E, P/P, User), press [SWR
ALL].
6
Press [Assign], turning it on.
If the selected register is locked, a confirmation
message appears asking whether or not to cancel the
operation. Press [OK] to return to the previous menu
display without carrying out the registration.
If the operation is carried out, the region selected in
step 5 is registered on the master timeline.
7
Select the number of the effect register.
8
Repeat steps 5 to 7 as required to set all regions and
register numbers to be saved on the master timeline.
9
In the <Store> group, press [Store].
To return to the state before saving the master
timeline content
In the <Store> group, press [Undo].
Recalling and Executing a
Master Timeline
For details about recalling a master timeline in the
numeric keypad control block, see “Recalling a Register
(Numeric Keypad Control Block)” (page 285).
Recalling and Executing a Master
Timeline (Flexi Pad Control Block)
Pressing the [MASTR EFF] button in the Flexi Pad control
block switches the memory recall section to effect
operation mode for recalling and executing master
timelines. The region set when the master timeline was
saved is recalled.
Flexi Pad control block
1
In the Flexi Pad control block, press the [MASTR
EFF] button.
This switches the memory recall section to effect
operation mode.
The bank recalled last and register number are
displayed on the top right button in the memory recall
section.
2
Select the target bank for operation using the bank
selection buttons.
No. Parameter Adjustment
3 Effect Reg Effect register number
MASTR EFF button
Memory recall section
Bank selection buttons
To Next Page
Loading...
