395
Setting the trackball and Z-ring sensitivity in fine
mode
In the <Trackball Fine Mode> group, select one of the
following.
1/2: Move at 1/2 speed
1/4: Move at 1/4 speed
1/8: Move at 1/8 speed
This setting is disabled in the following operation modes.
• Keyframe operation mode
• VTR/disk recorder/frame memory operation mode
Setting the sensitivity when recalling a menu
using double-press
In the <Double Click> group, select one of the following.
Fast: High speed
Normal: Normal
Slow: Low speed
Setting the Macro Execution Mode
1
In the Engineering Setup >Panel >Operation menu
(7326), press [Macro].
The Macro menu (7326.6) appears.
2
In the <Macro Execution Mode> group, select the
macro execution mode.
Normal: Normal execution
Step: Step execution
3
In the
<Attachment Set
ting Mode> gro
up, select
whether to enable cross-point button operations when
a macro attachment is set.
With Btn Function: Enable cross-point button
operations.
W/o Btn Function: Disable cross-point button
operations.
4
In the <Macro 2nd Recall Mode> group, set the action
to occur during macro execution or when a macro is
paused if the cross-point button that sets the macro
attachment set is double-pressed.
Continue: Execution of a macro that has been paused
is resumed, and an executing macro continues.
Cancel: A paused macro or a macro during execution
is terminated.
5
In the <Macro Recall Override> group, set the action
to occur during macro execution or when a macro is
paused if another macro is recalled.
Disable: Ignore the other macro recall.
Enable: Execute the other macro.
To set a cross-point button with a macro
attachment lit continuously
Press [Attchd Btn Indication], turning it on.
When the [MACRO ATTACH ENABLE] button in the
cross-point pad is on and lit orange, cross-point buttons
with a macro attachment are always lit green.
Setting the Cross-Point Control
Block to Key/AUX Bus Delegation
Mode
1
In the Engineering Setup >Panel >Operation menu
(7326), press [Xpt Module Operation].
The Xpt Module Operation menu (7326.12) appears.
2
In the <Bank Select> group, select the target bank to
set.
3
In the <Key Row Mode> group, select one of the
following.
Key Bus: Use the 1st row/2nd row as cross-point
button rows.
Key Deleg/AUX: Use the 1st row as a delegation
button row, and the 2nd row as a cross-point
button row for the bus/function selected in the 1st
row (key/AUX bus operation mode).
Assigning a bus/function to a 1st row
delegation button
1
In the Engineering Setup >Panel >Operation >Xpt
Module Operation menu (7326.12), press [Key Deleg/
AUX Assign].
The Key Deleg/AUX Assign menu (7326.13) appears.
The left side of the status area shows the 1st row button
numbers and the assigned buses/function names, and
the right side shows a list of assignable buses/function
names.
2
In the <Bank Select> group, select the target bank to
set.
3
Select the target button number to set.
4
Select a bus/function to assign.
5
Press [Set].
Note
To Next Page
Loading...
