301
To undo the saving of an effect
While the [STORE STATS] button is lit amber, press and
hold the [STORE STATS] button and press the [UNDO]
button.
Creating and Saving a
Master Timeline
You can save region information (information on any
regions, including the register numbers associated with the
regions) referred to as a master timeline in a dedicated
register. By recalling that register, you can manipulate the
regions and registers together.
Creating and Saving a Master
Timeline (Numeric Keypad Control
Block)
Creating and saving a master timeline
1
Press the [EFF] button.
The control block switches to effect operation mode,
and the [EFF] button and [RCALL] button light
amber.
2
Recall the effect to save on the master timeline by
specifying the register number for each region.
For details about the method of operation, see
“Recalling a register” (page 286).
3
Press the buttons for the regions you want to save on
the master timeline, turning them on.
4
Press the region selection button [MASTR], turning it
on.
The display shows “MASTR” and the last recalled
master timeline register number.
5
Press the [STORE] button, turning it on.
6
With the numeric keypad buttons, enter the number of
the register in which you want to save the master
timeline.
For details about selecting a register, see “Register
selection in the numeric keypad control block”
(page 285).
7
Press the [ENTER] button.
This saves the effect in the specified register.
The [RCALL] button and the [STORE STATS] button
light amber.
To Next Page
Loading...
