Sony XVS Series - Glow Settings; Mask Settings

224
4 Press [Flat Color] and set the parameters for the color
of the rear of the picture.
Applying the Fade effect
1 Open the DME >Enhanced Video Modify >Dim &
Fade menu (4173).
2 Press [Fade], turning it on.
3 Set the following parameters.
Glow Settings
Applying the Glow effect
1 Open the DME >Enhanced Video Modify >Glow
menu (4174).
2 Press [Glow], turning it on.
The key border function and glow function cannot be
enabled at the same time. The most recently set
function is enabled.
3 Set the following parameters.
4 Press [Matte] and set the glow color.
To invert the highlight areas
Press [Glow Invert], turning it on.
The highlight and non-highlight areas are inverted.
To mask the Glow effect with a selected pattern
Press [Mask] to open the DME >Video Modify >Mask
menu (4127), and set the type of pattern and modifiers (see
page 224).
When the signal format is 1080P, masking will cause the
edges to become blurred.
Mask Settings
Applying the Mask effect
1 Open the DME >Video Modify >Mask menu (4127).
2 In the <Mask> group, select the effect group you want
to apply the mask.
Effect Gp1: Posterization, Solarization, Nega, Sepia,
Mono, Contrast, Mosaic, Sketch, Metal
Effect Gp2: Defocus, Blur, Glow
3 Press [Position/Size].
4 Set the following parameters.
a) Pattern numbers 21, 24, and 304
5 To invert the mask source, press [Invert], turning it on.
6 Set the modifiers for the mask pattern as required.
When selecting [Aspect] and adjusting the pattern
aspect ratio
No. Parameter Adjustment
1 Start Point where dimming starts (dim
start point)
2 Gain Degree of dimming
No. Parameter Adjustment
1 Luminance Luminance
2 Saturation Saturation
3Hue Hue
No. Parameter Adjustment
1 Start Point where fading starts (fade
start point)
2 Gain Degree of fading
Note
No. Parameter Adjustment
1 Clip Reference level for highlight
detection
2 Gain Gain level for highlights
3 Soft Softness
No. Parameter Adjustment
1 Luminance Luminance
2 Saturation Saturation
3Hue Hue
Note
No. Parameter Adjustment
1 H Horizontal position
2 V Vertical position
3 Size Size of mask
4 Soft Softness of mask
5 Pattern Pattern number
a)
No. Parameter Adjustment
1 Aspect Aspect ratio
a)