Sony XVS Series - DME Wipe Modify Clear

152
To set the timing of transition completion
When the execution mode for a DME wipe crop transition
is set to [Last 5%], you can select the timing of transition
completion from 70% ([Last 30%]), 95% ([Last 5%]), and
100% ([Off]).
1 Open the M/E-1 >DME Wipe >Modify menu (1165).
2 In the <Crop Mode> group, press [Remove From
Begin].
The Remove From Begin menu (1165.1) appears.
3 In the <Release Transition> group, select the timing of
transition completion.
Last 30%: The transition completes at the end of 70%
of the transition execution time. The transition has
a dead zone from 70% to 95% of the transition
time.
Last 5%: The transition completes at the end of 95%
of the transition execution time. When the
transition completes, the cropping is removed
during the last 5% (enlarges).
Off: The transition completes at the end of the
transition execution time. During the last 5% of
the transition, the transition and cropping removal
proceed together.
DME Wipe Modify Clear
Press [Default Recall] at the lower left of the menu display,
turning it on, then press the VF6 button ([DME Wipe]) to
return the DME wipe settings to their initial status.
For details about initial status, see “Power-On (Startup)
State Selection” (page 366).
t: Transition execution
time
y: Change in transition
and cropping amount
Transition
Crop
t: Transition execution time
y: Change in transition and
cropping amount
Dead zone
Transition
Crop