356
If NFS (Network File System) is enabled in the Setup
menu, [Network] is added to the device for operations.
For details about NFS, see “Configuring the NFS Server”
(page 362).
To select a device
1
In the File menu, press the button on the left in the
device selection area above the list.
A pull-down menu appears.
2
Select the target device for operation.
Register: Register
Local Drive: Local drive
Removable Drive: Removable drive
Network: Files on a network (NFS)
The selected device name is displayed on the button on
the left in the device selection area.
3
Press the button on the right in the device selection
area.
The directory selection window appears.
Up to 40 directories are displayed per page, and you
can move between pages using the b and B buttons.
The maximum number of directories that can be
created is 120 for a removable drive and 200 for the
local drive or NFS.
4
Press the button for the target directory to use.
The selected directory name is displayed on the button
on the right in the device selection area.
• The devices that can be selected in the device
selection area vary depending on the function and
the menu.
• When [Register] is selected in the device selection
area, a directory cannot be specified.
Saving Files
This section describes saving snapshot register data to the
local drive or a removable drive as an example.
1
Open the File >Snapshot >Snapshot menu (7131).
2
In the device selection area in the list on the left, select
[Register].
3
In the device selection area in the list on the right,
select [Local Drive] or [Removable Drive], then
specify a directory.
4
Select the register to save and the destination file.
You can select more than one register.
To select all registers, press [ALL].
5
Press [t Save].
The data from the selected registers is saved.
If the specified destination already contains data, a
confirmation message appears. Select [Yes] to
overwrite the existing data.
Loading Files
This section describes loading a snapshot file from the
local drive or removable drive into a register as an
example.
1
Open the File >Snapshot >Snapshot menu (7131).
2
In the device selection area in the list on the left, select
[Register].
3
In the device selection area in the list on the right,
select [Local Drive] or [Removable Drive], then
specify a directory.
4
Select the register to which you want to load, and the
file to be loaded.
You can select more than one file.
To select all files, press [ALL].
5
Press [T Load].
The selected file is loaded.
Copying Files
You can copy files either within a directory or between
directories on the local drive or a removable drive.
This section describes copying a snapshot file from a
removable drive to the local drive as an example.
1
Open the File >Snapshot >Snapshot menu (7131).
2
In the device selection area in the list on the left, select
[Removable Drive], then specify a directory.
3
In the device selection area in the list on the right,
select [Local Drive], then specify a directory.
4
Select the source and destination files.
You can select more than one file.
To select all files, press [ALL].
Notes
To Next Page
Loading...
