431
Tally Copy Settings
You can copy the tally information for a particular source
to a different source.
The settings used are common to both parallel and serial
tallies.
Configuring Tally Copy
1
In the Engineering Setup >Router/Tally >Tally Copy
menu (7365), press [New].
The New menu (7365.1) appears.
2
Set the source to copy.
When setting more than one tally copy, you can
specify the copy-from source start and end addresses.
3
Set the source on the copy destination.
4
Press [Execute].
Modifying Tally Copy
1
In the Engineering Setup >Router/Tally >Tally Copy
menu (7365), press [Modify].
The Modify menu (7365.2) appears.
2
Select the copy-from and copy-to sources.
3
Press [Execute].
Deleting Tally Copy
1
In the Engineering Setup >Router/Tally >Tally Copy
menu (7365), select the tally copy.
2
Press [Delete].
No. Parameter Adjustment
1Copy From
(From)
Copy-from source start address
2Copy From
(To)
Copy-from source end address
No. Parameter Adjustment
3Copy To
(From)
Copy-to source start address
4Copy To
(To)
Copy-to source end address
No. Parameter Adjustment
1 Copy From Copy-from source
2 Copy To Copy-to source
To Next Page
Loading...
