Sony XVS Series

390
4 Perform the following operations, according to the
selection in step 3.
When [Menu Shortcut] is selected: When the 1st
row/2nd row button on the cross-point control
block is blinking, display the shortcut menu. Press
the target button to set to assign a shortcut. When
finished, press [Menu Shortcut] again.
When [Utility Command] is selected: Select a
command to assign in the list on the right side of
the status area.
a) DCU GPI Test Fire command only
When [Macro Recall] is selected: Select the macro
register to assign.
When [Shotbox Recall] is selected: Select the
shotbox register to assign.
5 Press [Action Set].
When [Menu Shortcut] is selected in step 3, it is not
necessary to press [Action Set].
To release the assignment
Select the target button to release, then press [Clear].
To display register names in the Utility Command
field
When [Macro Recall] or [Shotbox Recall] is selected in
step 3, you can select whether to display register names in
the Utility Command field.
To enable display, press [Reg Name Display], turning it
on.
For details about utility commands that can be assigned to
the 1st row/2nd row buttons, see “List of utility commands
and user preference button states” (page 385).
Settings names to show on the display
You can set the display of names on the display when
menu shortcuts or utility commands are assigned to the 1st
row/2nd row buttons.
When a macro register is assigned, the names specified in
the Macro menu are displayed on the display. When a
shotbox register is assigned, the names specified in the
Shotbox menu are displayed on the display.
1 In the Engineering Setup >Panel >Prefs/Utility >Xpt
Module Assign menu (7324.2), select the target button
to set.
2 Press [Name].
3 Enter a name of up to 8 characters in the keyboard
window, and press [Enter].
No. Parameter Adjustment
3 Command Utility command selection
4
a)
GPI No GPI number
No. Parameter Adjustment
3 Macro Macro register selection
No. Parameter Adjustment
3 Shotbox Shotbox register selection
Note