Interactive Command Set
348 SSU-2000 User’s Guide 12713020-002-2 Revision D – April 2004
KEEPALIVE
Use this command to support a “keep alive” mode that generates a recurring event,
based on a user settable time, to alert the upstream support system that the
SSU-2000 and associated communication path is functional.
Level 0: NA
Level 1:
KEEPALIVE
Displays the “keep alive” time, the length of time between
automatic events that are generated for upstream support systems.
Level 2: Same as level 1 operation
Level 3: Same as Level 2 operation with the following additions:
KEEPALIVE [TL1|SNMP] [time]
Options are:
TL1 Sets the TL1 session keep alive time
SNMP Sets the SNMP session keep alive time
time Value in minutes, minimum is 1 minute, maximum is 60
minutes. If 0 minutes are specified, it means ‘keep alive’
is disabled
Level 4: Same as level 3 operation
Remarks: None
Related: None
Restrictions: The ICS session in RS232 or telnet is not affected
To Next Page
Loading...
Need help?
General
