SYNAPTICON CIRCULO 7 - Page 484

General View
Detail View
3.1.8.2.2.1.3 Enable Profile position mode
To enable the mode, the value 1 (0001h) must be entered in object Modes of operation 0x6060. The object Op
mode display 0x6061 can be used to check if the op mode has been set correctly.
Synapticon Documentation
© 2021 Synapticon GmbH | Daimlerstraße 26 | D-71101 Schönaich Documentation v 4.11.0 | Built 2021-07-23 484/887