SYNAPTICON CIRCULO 7 - Page 7

1.4.1 SOMANET Braking Chopper 48V 500W
1.4.1.1 Overview
1.4.1.2 Technical Specs
1.4.1.3 Installing the module and setting the threshold voltage
1.4.1.4 Connecting the Board to DC-BUS
1.4.1.4.1 Suitable cables
1.4.1.4.2 Wiring
1.4.1.5 Failsafe Behavior
1.4.1.6 Multi-board option
1.4.1.7 LED
1.4.1.8 Dimensions
1.4.2 Sin/Cos Encoder Cable Adapter
1.4.2.1 Overview
1.4.2.2 Block Diagram
1.4.2.3 Connectors
1.4.2.3.1 Encoder Connector Top
1.4.2.3.2 Encoder Connector Bottom
1.4.2.3.3 Interface Connector
1.4.2.4 Mounting remarks
1.4.2.5 Strain relief
1.4.2.6 Soldered cables
1.4.3 Industrial I/O Cable Adapter
1.4.3.1 Overview
1.4.3.2 Block diagram
1.4.3.3 Pinouts
1.4.3.4 Connector details and mating parts
1.4.3.5 Strain relief
1.4.3.6 Soldered cables
1.4.4 ABI/BiSS Encoder Cable Adapter
1.4.4.1 Overview
1.4.4.2 Block Diagram
1.4.4.3 Connectors
1.4.4.3.1 Encoder Connector Top
1.4.4.3.2 Encoder Connector Bottom
1.4.4.3.3 Interface Connector
1.4.4.4 Mounting remarks
1.4.4.5 Strain relief
1.4.4.6 Soldered cables
1.4.4.7 Downloads
2 Commissioning and Tuning with SOMANET OBLAC Drives
2.1 OBLAC Drives Setup
2.1.1 OBLAC Drives Box
2.1.1.1 Connectors
2.1.1.2 Installation
2.1.1.3 Powering the box off and resetting
2.1.1.4 Open OBLAC Drives
286
286
287
288
289
289
289
290
290
291
292
293
293
293
294
294
295
295
296
297
297
298
298
298
300
300
301
302
303
303
303
304
304
305
305
306
307
307
307
308
309
310
310
311
312
312
Synapticon Documentation
© 2021 Synapticon GmbH | Daimlerstraße 26 | D-71101 Schönaich Documentation v 4.11.0 | Built 2021-07-23 7/887