USTER
®
HVI SPECTRUM
Instruction Manual
Uster Technologies, Inc. Chapter 7
Testing Procedures • Page 7-10
2.7 Exit from Testing
When you have finished testing the samples for the specified lot, exit the
screen by following these steps:
• Select the EXIT TEST MODE button.
Attention: Be sure that you DO NOT exit System Testing
until the test series for the last sample is completely
finished. If you exit system testing by selecting
E
XIT
T
EST
M
ODE
too soon, you will lose the test results that have
not been transmitted and will have to repeat all tests on
that sample to regain the results.
2.8 Printing the Test Results
Test results can be viewed and printed at any time during testing by
selecting the QUICK REPORT button on the
HVI
SPECTRUM
TESTING
screen. (See Chapter 9 Quick Reports for additional information)
To Next Page
Loading...
