USTER
®
HVI SPECTRUM
Instruction Manual
Uster Technologies, Inc. Chapter 10
Bale Manager • Page 10-11
• Next, indicate your selection in the Laydown field. This selection
is used to indicate the type of bale opening equipment used in the
plant.
o Plucker is an automated system, whereas Hopper is manual.
If Hopper is selected, then the number of hoppers in a row
must be entered in the adjacent field.
Note:
The Automatic Import from HVI SPECTRUM can be turned off/on
as needed. If no data is being imported via the import utility, this
feature should be disabled. If data is being imported, click inside the
On/Off field to turn on the auto import feature.
• Select the growth area from the pull-down list in the adjacent field.
Note:
If desired, you can select the P
RINT
S
TATUS
R
EPORT
button to
print a status report showing the current system settings. The report will
print to the default printer.
• Enter the appropriate settings for the
HVI SPECTRUM
according to
your needs and select the OK button to save the settings.
4 Defining Categories
4.1 How the Category System Works
In the category system, each bale is placed into a category for each
fiber property. The category definition for each fiber property consists
of the number of categories, the ending point of the first category, and
the interval between the categories. The category definitions require an
estimate of the average value and range of each property for the bales
in your inventory. Instructions to determine category definitions are
explained in the following sections.
To Next Page
Loading...
