USTER HVI SPECTRUM - Calibration Test

USTER
®
HVI SPECTRUM Instruction Manual
Uster Technologies, Inc. Chapter 5
System Check • Page 5-7
2.2.2 Calibration Test
To begin the Length/Strength system check:
1. Check the Standard Values for Short and Long cotton (length,
strength, uniformity, and micronaire). Save any changes by
pressing the SAVE STD VALUES button.
Note: HVI SPECTRUM II users must select either L/S Unit 1 or L/S Unit
2 from the pull-down list.
2. Press the S
TART TEST button.
3. When testing is finished, select the END TEST button.