USTER HVI SPECTRUM - Software Functions: Testing, Setup, and Management

USTER
®
HVI SPECTRUM Instruction Manual
Uster Technologies, Inc. Chapter 3
Note: The example above applies to all function buttons with the
exception of the T ESTING button. When the testing screens are exited,
all functions on the HVI SPECTRUM M AIN M ENU are enabled.
2.1.1 Testing
Software Overview • Page 3-4
The T
ESTING button is used to perform the normal
testing process of fibers. The testing sequence is
described in detail in Chapter 7 .
Figure 3-4: Testing Button
2.1.2 Setup
The SETUP button accesses a series of functions,
which are described below.
Figure 3-5: Setup Button
These include the following:
• Color Chart — is used to define/adjust the color chart(s) settings.
• Lot Limits — is used to define/adjust the lot limits settings.
• Configure — is used to define/adjust the system configurations.
• Diagnostics — is used to perform a series of diagnostic checks to
ensure that the system is functioning properly.
• System Check — is used to determine whether or not the
HVI
SPECTRUM instrument requires calibration.
• Calibrate — is used to calibrate the various testing components.