USTER HVI SPECTRUM - Retest Tolerance Tab

USTER
®
HVI SPECTRUM Instruction Manual
Uster Technologies, Inc. Chapter 6
Configurations • Page 6-15
4. The TEMPERATURE AND RH tab is used to set the upper and lower
limits for temperature and relative humidity. Selections to turn
these features on/off are offered in addition to an alarm on/off
selection.
Note: The alarm for the Temperature and RH levels sounds when either
of the high or low limits is reached.
Follow the steps below to make changes to the system
configuration under the TEMPERATURE AND RH tab:
1. Check or uncheck the box beside the TEMPERATURE AND RH
ALARM ON/OFF to activate/deactivate the alarm. An unchecked
(blank) box indicates the alarm is OFF.
2. Enter the upper and lower limits for Temperature and Relative
Humidity in the appropriate fields.
3. When you are finished, select the A
PPLY button.
4. Select the OK button to save the changes and exit the screen.
2.5 Retest Tolerance Tab
1. Access the S
YSTEM CONFIGURATION screen by selecting the SETUP
button from the
HVI SPECTRUM MAIN MENU.
2. Next, select the CONFIGURE button.
3. The SYSTEM CONFIGURATION screen will appear: