USTER HVI SPECTRUM - Table 14-4: Error Messages

USTER
®
HVI SPECTRUM Instruction Manual
Uster Technologies, Inc. Chapter 14
Appendix • Page 14-27
“Error: Elevator not at top
position when starting
Length/Strength cycle”
Reset and initialize Length/Strength
cabinet to continue.
“Error: Elevator not at top
position when taking
sample”
Reset and initialize Length/Strength
cabinet to continue.
"Error: Breaker not
positioned to take data”
Reset and initialize Length/Strength
cabinet to continue.
“Error: Elevator not in correct
position"
Reset and initialize Length/Strength
Cabinet to continue.
"Error: Positioner not in
correct position”
Reset and initialize Length/Strength
Cabinet to continue.
"Error:Breaker not in correct
position"
Reset and initialize Length/Strength
Cabinet to continue.
Table 14–4: Error Messages