USTER HVI SPECTRUM - Export Options

USTER
®
HVI SPECTRUM Instruction Manual
Uster Technologies, Inc. Chapter 8
Reports • Page 8-18
3.9.2 Export Options
Export Options include:
• User Named Disk File — Enter the path (if required) and file
name in the field located to the right of this option (i.e. data to be
stored in a file named EXPORT.DAT and written to a floppy disk in
the A:\ drive would be entered as A:\EXPORT.DAT).
• Identifier Named Disk File — Data for each selected identifier
will be exported to a separate file. The filename(s) will be the
same as the identifier name(s). Enter the path in the field located
to the right of this option.
1. Select the desired destination by checking the button beside either
User Named Disk File or Identifier Names Disk File.
2. Choose which type of data you want to export by checking
Accepted Data, Rejected Data, or both.
3. Metric Length Units – allows you to export data in metric units
even if this was not specified in configuration.
4. Select the Lot ID for the file that is to be exported from the Lot
Identifier area.
5. Press the OK button to finish.