USTER
®
HVI SPECTRUM
Instruction Manual
Uster Technologies, Inc. Chapter 8
Reports • Page 8-10
When the report is generated, it can include:
Accepted Data — Only tests that are acceptable according to the lot
limit specification at test time will be included in the report.
Rejected Data — Only tests that are rejected according to the lot limit
specification at test time will be included in the report.
Accepted and Rejected Data — All tests are included in the report,
whether or not they were accepted or rejected according to the lot limit
specification.
Accepted and rejected tests are determined by the lot limits as they were
at the time of testing. Out-of-limit values are also shown in BLUE and
rejected properties are shown in BOLD on an on-screen report.
Rejected properties are shown in BLUE on a printed report.
• A report can be sorted in ascending value by the ID numbers of the
samples or chronologically by the date of data generation.
• Data can be displayed in either Inches or Metric Units.
• You can choose to print a Full Report or a Summary Report.
To Next Page
Loading...
