USTER
®
HVI SPECTRUM
Instruction Manual
Uster Technologies, Inc. Chapter 10
Bale Manager • Page 10-6
When using the MODULE Test Mode, a screen will appear showing
the mean, standard deviation, and the percent coefficient of
variance (%CV) of various properties (length, strength, Rd, +b,
elongation, uniformity, etc.). If these values are correct, you can
choose to accept the data and these averaged values will be
applied to the lot.
Once this is done, select the starting Bale ID number and the
number of bales that are to be included in the lot.
The system will automatically number the bales and store them in
the database with the average values that were accepted.
3. Select the Growth Area where the lot originated from the pull-
down list.
Note:
Growth areas are added and deleted using the Define Category
screen.
4. Select those files that are to be imported as “
filename.
dat”.
Multiple files may be imported by selecting multiple entries. The
specific Lot ID number will usually be the
filename
.
The Data File item is used to import data from previous
versions of
DATA MANAGER
and
HVI SPECTRUM
.
5. Select the data source from the drop down list in the Data File
area or leave the default entry, which will be the current version of
the
HVI SPECTRUM
.
6. Verify the date of when the data was generated (this also defaults
to the current date). If needed, enter another date.
7. When all information has been accurately entered, select the
I
MPORT button to begin importing the data.
8. The data will be imported from the specified location.
To Next Page
Loading...
