USTER HVI SPECTRUM - Page 7

USTER
®
HVI SPECTRUM Instruction Manual
iii
2.3.1 Calibration Check .........................................5-8
2.3.2 Calibration Test.............................................5-8
CHAPTER 6 CONFIGURATIONS .......................... 6-1
1 INTRODUCTION ...................................................................6-1
2 SYSTEM CONFIGURATION SCREEN............................................6-1
2.1 Test Setup Tab..........................................................6-2
2.1.1 Lot Limits ......................................................6-5
2.1.2 Creating Lot Limits .........................................6-6
2.1.3 Edit Lot Limits ................................................6-9
2.1.4 Delete Lot Limits...........................................6-11
2.2 Measurement Selection Tab .....................................6-12
2.3 General Setup Tab .................................................6-13
2.4 Temperature and RH Tab.........................................6-14
2.5 Retest Tolerance Tab ...............................................6-15
2.6 USTER® SCI Regression Coefficients .........................6-17
2.6.1 Changing the SCI Equation...........................6-18
CHAPTER 7 TESTING PROCEDURES ..................... 7-1
1 OVERVIEW.........................................................................7-1
2 TESTING SEQUENCE QUICK REFERENCE .....................................7-2
2.1 Step 1—Access the Main Testing Screen .....................7-3
2.2 Step 2—Choose from Additional Selections .................7-4
2.3 Step 3—Operator Identification..................................7-5
2.4 Step 4—Identify the Sample.......................................7-6
2.5 Step 5—Perform the Micronaire Test ...........................7-7
2.6 Step 6—Perform L/S and C/T (Optional Module) Tests..7-9
2.7 Exit from Testing.....................................................7-10
2.8 Printing the Test Results............................................7-10
3 D
ETERMINING THE ACTION WHEN COTTON FAILS TO MEET LOT LIMITS7-11
CHAPTER 8 REPORTS ......................................... 8-1
1 INTRODUCTION ...................................................................8-1
2 C
ATEGORIES.......................................................................8-2
2.1 Creating Categories .................................................8-2
2.2 Overview of the Category System...............................8-4
2.3 Changing the Pre-Defined Categories..........................8-5
3 DESIGNING/DELETING/MODIFYING REPORTS..............................8-6
3.1 Type and Format of Test Data.....................................8-6