EasyManuals Logo

Voltech AT5600 User Manual

Voltech AT5600
438 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #254 background imageLoading...
Page #254 background image
C H A P T E R 1 1 M A I N T E N A N C E
AT5600 User Manual 98-119 issue 14 Page 254
11.1.2. Removing the air filters
The filters can be cleaned with water or suction using a vacuum cleaner.
11.2. Test Probes
If any test probe gets damaged, they can be removed using needle nose pliers.
Grasp the test probe firmly using the pliers and pull straight up. The 3 mm test
probes are Ingun (UK) Ltd Part Number GK S113 204 300 R 1502.
The test pins on the bottom of the test fixture can also tarnish with age, and
accrue dirt and grease from the manufacturing environment.
Voltech recommends Chemtronics Pow-R-Wash VZ for cleaning the test pins/
https://www.chemtronics.com/pow-r-wash-vz
11.3. Power Cords
Regularly check the power cord for any signs of wear and replace it if necessary.
11.4. Cleaning
Clean only using a damp cloth.
Do not use any cleaning chemicals as damage may occur to surfaces.
Do not allow water to run inside.
Ensure surfaces are thoroughly dry before use
.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Voltech AT5600 and is the answer not in the manual?

Voltech AT5600 Specifications

General IconGeneral
BrandVoltech
ModelAT5600
CategoryTest Equipment
LanguageEnglish

Related product manuals