Voltech AT5600 User Manual

C H A P T E R 3 – U S I N G T H E A T 5 6 0 0
AT5600 User Manual 98-119 issue 14 Page 51
3.5. Results Printing
The AT5600 can be configured to automatically print results at the end of each
program run and the results can be printed using the PRINT soft-key through the
user interface as detailed in Section 8.
Automatic printing is configured as part of the test program using the Editor
software. Please see section 14.5.1, “Setting the Program Options”, about
automatic printing configuration.
All printing has been tested using the Epson TM-T88V printer. This is a very high-
speed printer with print speeds up to 300mm per second.
Although other compatible models may work correctly, Voltech can only
guarantee operation with this printer.
See Section 5.5 USB Printer Setup for complete instructions to set-up the Epson
TM-T88V printer including changing to USB Printer Class.
3.5.1. Report Format
The format of the print output uses simple characters to maximize the speed of
printing. ASCII characters are used using a fixed width font to give a consistent
presentation. The width of the print is 56 characters and centralized to the printer
paper.
--------------------------------------------------
| VOLTECH INSTRUMENTS |- Note 1
| AT5600 PART UNDER TEST REPORT |
| |
|S/N: 100011200016 |- Note 2
|F/W: 0.007.053 |- Note 3
|OPERATOR: TEK |- Note 4
|BATCH: 015 |- Note 5
|PART NUM: INDUCTOR |- Note 6
|PART S/N: X00058 |- Note 7
|DATE: 18-DEC-15 10:34:43 |- Note 8
|RESULT: *** FAIL *** |- Note 10
--------------------------------------------------
--------------------------------------------------
|ID TYPE MINIMUM MAXIMUM RESULT P/F |
|1 R 80.00mΩ 100.0mΩ 90.66mΩ P 0000|- Note 9
| 2 LS 2.000uH 6.000uH 4.403uH P 0000|
| 3 QL 20.00 30.00 31.45 F 0000|
| *** FAIL *** |- Note 10
--------------------------------------------------
Note:

Voltech AT5600 Specifications

General

Brand	Voltech
Model	AT5600
Category	Test Equipment
Language	English