C H A P T E R 1 4 - A T E D I T OR
AT5600 User Manual 98-119 issue 14 Page 285
Operato r Numbering
During program execution, the operator will be prompted to enter his or her
identity code. All server results will then be tagged with this code.
Batch Numb ering
During program execution, the operator will be prompted to enter a batch number,
which will be attached to the server test results.
Serial Numbering
During program execution, the operator will be prompted to enter a serial number
for each transformer (or you can select auto-increment). The number will then be
attached to the server results for the next transformer tested.
Send Results to Server
Select this option if you wish to have the tester send all the measurement results
back to the Server PC for archive or analysis.
Send Retry Re sults to Server
Enable this function if you wish the Server archive to contain the results from the
additional measurements associated with re-running a program, for example after
execution has been halted by the STOP ON FAIL program option.
To Next Page
Loading...
Need help?
General
