C H A P T E R 1 4 - A T E D I T OR
AT5600 User Manual 98-119 issue 14 Page 306
If errors are encountered, such as a shorting link is not fitted, the editor will display
the appropriate warning message, and allow you either to try again, or to cancel
the compensation.
When the compensation measurements have been successfully completed, the
compensation values for each test in the program will be stored inside the tester.
Any subsequent measurements (started as described above by clicking on Tester
- Run Program) will return compensated results to the Editor.
To determine whether it is necessary to compensate or not, simply try it. If any of
the results change significantly, then it should be done.
REMEMBER: Whenever you make changes to the program, the
compensation results in the tester will no longer be valid.
Make sure to compensate again each time you download a test program to
an AT Series Tester.