Woodward LS-5 v2 Series - Page 164

12946 Open CBB unload 2 Determined by
LogicsManager
[(09.06& 1)&1]
Once the conditions of the
LogicsManager have been ful󰈡lled the
LS-5 opens the CBB with unloading, if
no other LS-5 with higher priority likes
to do the same.
Notes
If a close or open command is active
but is blocked by another device with
higher priority the display shows "CBB
request".
Only in operation mode AUTOMATIC.
No access in application mode
A05
.
12947 Open CBB immediately 2 Determined by
LogicsManager
[(09.04&1)&1]
Once the conditions of the
LogicsManager have been ful󰈡lled the
LS-5 opens the CBB immediately.
Notes
Only in operation mode AUTOMATIC.
No access in application mode
A05
.
12948 Enable close CBB 2 Determined by
LogicsManager
[(09.04&!08.05)&!
06.21]
Once the conditions of the
LogicsManager have been ful󰈡lled the
LS-5 closes the CBB, if no other LS-5
with higher priority likes to do the
same. (Provided the conditions for
dead bus closure or synchronization
are true.)
Notes
If a close or open command is active
but is blocked by another device with
higher priority the display shows "CBB
request".
Only in operation mode AUTOMATIC.
No access in application mode
A05
.
4.4.2.4.1 Synchronization CBB
ID Parameter CL Setting range
[Default]
Description
5729 Synchronization CBB 2 [Slip frequency] The LS-5 instructs the frequency
controller (e.g. easYgen) to adjust the
frequency in a way, that the
frequency of the variable system is
marginally greater than the target.
When the synchronizing conditions are
reached, a close command will be
issued. The slipping frequency is
positive to avoid reverse power.
Phase matching The LS-5 instructs the frequency
controller (e.g. easYgen) to adjust the
phase angle of the variable system to
164 LS-5 v2 Series 37650
4 Con󰈡guration
4.4 Con󰈡gure Application
Released