Name: Woodward LS-5 v2 Series
Brand: Woodward
Rating: 4 (1 reviews)

To Next Page

To Previous Page

This is no translation but the original Technical Manual in English.

Designed in Germany.

Woodward GmbH

Handwerkstr. 29

70565 Stuttgart

Germany

Telephone: +49 (0) 711 789 54‑510

Fax: +49 (0) 711 789 54‑101

Email: stgt-info@woodward.com

Internet: http://www.woodward.com

2 LS-5 v2 Series 37650

Released

Table of Contents6
General Information14
About this Manual14
Revision History14
Depiction of Notes and Instructions15
Copyright and Disclaimer16
Service and Warranty17
Safety17
Intended Use17
Personnel18
General Safety Notes19
Protective Equipment and Tools22
System Overview23
Display and Status Indicators24
Hardware Interfaces (Terminals)28
Application Modes28
Operation Modes29
Synch. Check Functionality29
Installation32
Mount Unit (Sheet Metal Housing)32
Mount Unit (Plastic Housing)33
Clamp Fastener Installation35
Screw Kit Installation37
Setup Connections38
Terminal Allocation38
Wiring Diagram39
Power Supply42
Voltage Measuring43
Breaker Interaction43
System a Voltage44
System B Voltage52
Current Measuring58
Current Measuring (System A)58
Current Measuring (System B)60
Power Measuring62
Power Factor Definition63
Analog Input 0/4 to 20 Ma64
Discrete Inputs66
Relay Outputs67
Serial Interface68
Interface68
Service Port69
CAN Bus Interface71
Connecting 24 V Relays73
Configuration75
Basic Setup75
Configure Language/Clock75
Configure Display80
Enter Password80
System Management82
Password System85
Configure Status/Monitoring (Home) Screen85
Configure Measurement86
Configure Transformer91
Configure Monitoring94
System a94
System a Operating Voltage / Frequency95
System a Decoupling97
Phase Shift100
Df/Dt (ROCOF)102
System a Overfrequency (Levels 1 & 2) ANSI# 81O103
System a Underfrequency (Level 1 & 2) ANSI# 81U105
System a Overvoltage (Level 1 & 2) ANSI# 59106
System a Undervoltage (Level 1 & 2) ANSI# 27108
System a Voltage Asymmetry110
4.3.1.10 System a Voltage Increase112
4.3.1.11 Setup System a for VDE-AR-N 4105113
4.3.1.12 QV Monitoring119
4.3.1.13 System a Time-Dependent Voltage122
System a Phase Rotation126
System B127
System B Operating Voltage / Frequency128
System B Voltage Phase Rotation129
Breaker131
Cba131
Synchronization CBA132
CBA Unload Mismatch133
Cbb134
Synchronization CBB135
CBB Unload Mismatch136
System a / System B Phase Rotation137
CB Closed Transition Monitoring139
Voltage Plausibility140
Operating Range141
CAN Interface143
Battery Overvoltage (Level 1 & 2)144
Battery Undervoltage (Level 1 & 2)146
Free Configurable Alarms147
Multi-Unit Missing Members149
Global Settings150
4.3.11.1 Alarm Acknowledgement150
Configure Application151
Application Mode151
Breakers153
Dead Bus Closure CB153
Dead Bus Closure CBA/CBB154
Configure CBA157
Configure CBB162
Synchronization Configuration167
Configure Synchronous Network171
Configure Breaker Transition Mode172
Configure Segment178
Automatic Run180
Inputs and Outputs181
Analog Input 1181
Value Format - Examples185
Discrete Inputs187
Discrete Outputs (Logicsmanager)190
Configure Interfaces192
General192
CAN Interface192
CAN Interface 1193
Additional Server Sdos (Service Data Objects)196
Receive PDO {X} (Process Data Object)197
Transmit PDO {X} (Process Data Object)198
RS-232 Interface202
Interface203
Modbus Protocol (5300 Multiple)204
Configure Logicsmanager205
Configure Counters211
Operation214
Access Via PC (Toolkit)214
Install Toolkit214
Install Toolkit Configuration Files216
Configure Toolkit217
Connect Toolkit219
View and Set Values in Toolkit221
Special Screens223
Front Panel Access228
Basic Navigation228
Parameter Setting Screens236
Navigation Screens236
Value Setting Screens237
Logicsmanager Setting Screens238
Main Menu Screens239
Main Screen Display239
Alarm List241
System a242
System B242
System Angles243
Synchroscope243
Logicsmanager Conditions244
Event History245
States Easygen245
States246
Segments246
5.2.3.12 Discrete Inputs/Outputs247
5.2.3.13 Analog Input247
5.2.3.14 System a Decoupling Thresholds248
Test System a Decoupling (VDE-AR-N 4105)250
5.2.3.16 Counters250
5.2.3.17 Actual Date and Time251
5.2.3.18 Version251
Change Operating Modes252
Operating Mode MANUAL253
Operating Mode AUTOMATIC254
Restore Language Setting254
Application256
Application Modes Overview256
LS-5X2: Stand-Alone Application Mode256
LS-5X2 & Easygen-3400/3500 or Easygen-3400XT/3500XT: Common Application Modes257
LS-5X2 View257
Easygen-3400/3500 or Easygen-3400XT/3500XT View258
Setup Stand-Alone Applications (Mode A01)259
Setup Easygen & Slave LS-5X2 Applications (Mode A05)262
Introduction262
Setup Easygen & Independent LS-5X2 Applications (Mode A02)264
Introduction264
General Functions267
General Preparation267
Setup Mains Measurement with Easygen268
Setup Mains Decoupling with Easygen269
Setup Mains Decoupling with269
Setup Run-Up Synchronization in LS-5 Mode272
Setup AMF Start in LS-5 Mode272
Setup Manual Breaker Control in LS-5 Mode275
Setup LS-5 Command Bits from Easygen to LS-5275
Setup LS-5 Flags from LS-5 to LS-5 and Easygen276
H-Configuration with Two Easygen and Two Incoming Mains and Tie-Breaker278
Setup VDE-AR-N 4105 Applications290
Introduction290
Decoupling Device290
Multiple Easygen-3500XT (Mode GCB/L-GGBMCB) with LS-522 as Separate Mains Decoupling Device291
Breaker Feedback Security Procedure292
Introduction292
Function293
Interfaces and Protocols296
Interfaces296
Interfaces Overview296
CAN Interfaces297
CAN Interface 1 (Guidance Level)297
Serial Interfaces297
Service Port (RS-232/USB)297
RS-485 Interface298
Protocols298
Protocols Overview298
Canopen Protocol299
Modbus Protocol300
Technical Specifications305
Technical Data305
Measuring Values305
Ambient Variables306
Inputs/Outputs306
Interface307
Battery308
Housing308
Approvals309
Generic Note309
Environmental Data309
Accuracy310
Appendix313
Characteristics313
Triggering Characteristics313
Data Protocols315
Canopen315
Data Protocol 5301 (Basic Visualization)315
Data Protocol 5302 (Basic Visualization)333
Protocol 6003 (LS-5 Communication)350
Modbus355
Data Protocol 5300 (Basic Visualization)355
Additional Data Identifier399
Transmit Data399
Logicsmanager Reference399
Logicsmanager Overview399
Logical Symbols402
Logical Outputs403
Logical Command Variables407
Group 00: Flags Condition 1407
Group 01: Alarm System409
Group 02: Systems Condition409
Group 04: Applications Condition411
Group 05: Device Related Alarms413
Group 06: System B Related Alarms413
Group 07: System a Related Alarms413
Group 08: System Related Alarms414
Group 09: Discrete Inputs415
Group 10: Analog Inputs415
9.3.4.11 Group 11: Clock and Timer416
9.3.4.12 Group 13: Discrete Outputs416
Group 17: Alarm System 2416
Group 24: Flags Condition417
Group 26(/1-2): Commands Device 33 to 48418
Group 27(/1-2): Commands Device 49 to 64420
9.3.4.17 Group 28: LS-5 System Conditions423
Group 29(/1-3): Commands Device 1 to 16423
Group 30(/1-3): Commands Device 17 to 32426
Factory Settings428
Event and Alarm Reference432
Alarm Classes432
Status Messages433
Event History435
Event Messages435
Alarm Messages436
Additional Application Information441
Synchronization of System a and System B441
Glossary and List of Abbreviations443
Index445

Woodward LS-5 v2 Series User Manual

Table of Contents

Questions and Answers:

Woodward LS-5 v2 Series Specifications

Related product manuals

Brand	Woodward
Model	LS-5 v2 Series
Category	Controller
Language	English