System Setup
9 - 224
9.21.2.2 The inspection notice window
1. Select {=PM} in the main menu.
2. Select {=INSPECTION NOTICE}.
– The inspection notice window appears.
Each item on the screen represents the following description.
NOTICE
When the inspection signal is turned ON or the message is displayed, perform the
inspection by an authorized personnel or the YASKAWA representative (listed on the back
cover of this instruction manual). The message is displayed continuously until the robot
controller is inspected.
Inspection items
The contents of the inspection are shown. The contents differ depending on the
model of manipulators. For details of the contents, refer to the robots instruction
manual corresponding to the model.
REMAINING
The remaining time to the inspection is shown. When the SERVO power is ON, the
measurement automatically starts and the numeric value is reduced. When the val-
ue is “0” in this item, the inspection signal is turned ON and the message is shown.
INTERVAL
The time interval of the inspection is shown.
ESTIMATE
The estimated date for the inspection is shown.
ձ ղ
մ
ճ
1
2
3
4
To Next Page
Loading...
