Connection
5 - 56
7. Run the general-purpose I/O signal cables through the general-purpose I/O board
(JANCD-AIO0-E) as shown by the red line in the figure below.
NOTICE
For the details of the connection, refer to “Wiring Procedure of the Terminal Block” in
chapter 15.16 "General purpose I/O board"”
Fix the cable on the door and right side by using the cable ties as the figure.
Note the following two points:
• No tension is found to the cables when the door is fully opened (Cable length between
fixing part of the door side and the right side: approximately 150 mm).
• Be careful not to get stuck the cables between the main body of the controller and its
door when the door is closed.
To Next Page
Loading...
