Miscellaneous Imager Options
125
FIPS Mode
Parameter # 736 (F1h E0h)
The Federal Information Processing Standard (FIPS) 140-2 is a U.S. government computer security standard used
to accredit cryptographic modules. FIPS enabled DS3678 scanners and cradles offer this secure mode of
operation.
To enable the FIPS mode of operation (disabled by default), scan the Enable FIPS bar code. The scanner attempts
to establish a secure session with the cradle to which it is connected. On success, the scanner lights an amber
LED on every trigger pull to signal that all data will be transmitted over Bluetooth in a secure fashion. On failure, the
scanner will sound transmission failure error message on every attempt to transmit data.
To disable the FIPS mode, scan the Disable FIPS bar code at any time.
NOTE: FIPS Mode is only supported when paired with the STB3678 cradle.
Enable FIPS
(1)
* Disable FIPS
(0)
To Next Page
Loading...
Need help?
General
