Zebra RS6000 User Manual

Miscellaneous Imager Options
113
Scanning Sequence Examples
In most cases, scanning one bar code sets the parameter value. For example, to set the beeper tone to high, scan
the High Frequency (beeper tone) bar code listed under Beeper Tone on page 119. The RS6000 issues a fast
warble beep and the LED turns green, signifying a successful parameter entry.
Other parameters, such as Data Transmission Formats, require scanning several bar codes. See these
parameter descriptions for this procedure.
Errors While Scanning
Unless otherwise specified, to correct an error during a scanning sequence, just re-scan the correct parameter.
User Preferences/Miscellaneous Options Parameter Defaults
Table 9 lists defaults for user preferences parameters. To change the default values:
• Scan the appropriate bar codes in this guide. These new values replace the standard default values in
memory. To recall the default parameter values, see Default Parameters on page 115.
• Configure the RS6000 using the 123Scan
2
configuration program (see 123Scan2 on page 102).
NOTE: See Standard Default Parameters for all user preferences, hosts, symbologies, and miscellaneous
default parameters.
Table 9 User Preferences Parameter Defaults
Parameter
Parameter
Number
1
SSI
Number
2
Default
Page
Number
User Preferences
Set Default Parameter Restore Defaults 115
Parameter Bar Code Scanning 236 ECh Enable 116
Beep After Good Decode 56 38h Enable 117
Beep on Insertion 288 Enabled 117
Beeper Volume 140 8Ch High 118
Beeper Tone 145 91h High 119
Beeper Duration 628 F1h 74h Medium 120
Suppress Power Up Beeps 721 F1h D1h Do Not Suppress 120
Low Battery Indication 779 F2h 08h Enable 121
Hand-Held Trigger Mode 138 8Ah Level 122
1. Parameter number decimal values are used for programming via RSM commands.
2. SSI number hex values are used for programming via SSI commands.

Zebra RS6000 Specifications

General

Brand	Zebra
Model	RS6000
Category	Barcode Reader
Language	English