To Next Page

To Previous Page

Miscellaneous Imager Options

135

Select no Code ID character, a Symbol Code ID character, or an AIM Code ID character. For Code ID characters,

see Programming Reference on page 317.

Prefix/Suffix Values

Key Category Parameter # P = 99, S1 = 98, S2 = 100 (SSI # P = 63h, S1 = 62h, S2

= 64h)

Decimal Value Parameter # P = 105, S1 = 104, S2 = 106 (SSI # P = 69h, S1 = 68h,

S2 = 6Ah)

You can append a prefix and/or one or two suffixes to scan data for use in data editing. To set a value for a prefix

or suffix, scan a four-digit number (i.e., four bar codes from Alphanumeric and Numeric Bar Codes) that

corresponds to that value. See ASCII Character Sets for the four-digit codes.

When using host commands to set the prefix or suffix, set the key category parameter to 1, then set the 3-digit

decimal value. See ASCII Character Sets

for the four-digit codes.

The default prefix and suffix value is 7013 <CR><LF> (the Enter key). To correct an error or change a

selection, scan Cancel on page 324

NOTE: If you enable Symbol Code ID Character or AIM Code ID Character, and enable Transmit “No Read”

Message on page 139, the RS6000 appends the code ID for Code 39 to the NR message.

Symbol Code ID Character

(2)

AIM Code ID Character

(1)

*None

(0)

NOTE: To use Prefix/Suffix values, first set the Scan Data Transmission Format on page 136.

Zebra RS6000 User Manual

Other manuals for Zebra RS6000