Zebra RS6000 - Trigger Assembly Replacement; Trigger Assembly Removal; Trigger Assembly Installation

Maintenance and Troubleshooting
287
Trigger Assembly Replacement
Trigger Assembly Removal
To remove the Trigger Assembly:
1. Turn the RS6000 upside-down.
2. Remove the Large Comfort Pad. See Large Comfort Pad Removal on page 284.
3. Remove locking screw using a T6 Torx screwdriver.
Figure 61 Removal of Trigger Assembly
4. Rotate the Trigger Assembly to align with the back of the RS6000.
5. Lift the Trigger Assembly off the housing.
Trigger Assembly Installation
To install the Trigger Assembly:
1. Turn the RS6000 upside-down.
2. Position the Trigger Assembly to align with the back of the RS6000.
3. Lower the Trigger Assembly onto the housing.
Locking Screw
RS6000 Back