Zebra RS6000 - Continuous Bar Code Read; Unique Bar Code Reporting

Miscellaneous Imager Options
126
Continuous Bar Code Read
Parameter # 649 (SSI # F1h 89h)
Enable this to report every bar code while the trigger is pulled.
Unique Bar Code Reporting
Parameter # 723 (SSI # F1h D3h)
Enable this to report only unique bar codes while the trigger is pulled. This option only applies when Continuous
Bar Code Read is enabled.
NOTE: Zebra strongly recommends enabling Picklist Mode on page 124 with this feature. Disabling Picklist
Mode can cause accidental decodes when more than one bar code is in the RS6000's field of view.
*Disable Continuous Bar Code Read
(0)
Enable Continuous Bar Code Read
(1)
Disable Continuous Bar Code Read Uniqueness
(0)
*Enable Continuous Bar Code Read Uniqueness
(1)