Maintenance and Troubleshooting
282
containing any of the harmful ingredients listed above are used prior to handling the device, such as hand sanitizer
that contain ethanolamine, hands must be completely dry before handling the device to prevent damage to the
plastics.
Cleaning Materials Required
• Alcohol wipes
• Lens tissue
• Cotton tipped applicators
• Isopropyl alcohol
• Can of compressed air with a tube.
Cleaning Frequency
The cleaning frequency is up to the customer’s discretion due to the varied environments in which the WT6000
units are used. They may be cleaned as frequently as required. However when used in dirty environments it may
be advisable to periodically clean the scanner exit window to ensure optimum scanning performance.
Cleaning the RS6000
Housing
Using alcohol wipes, wipe the housing.
Exit Window
Wipe the exit window periodically with a lens tissue or other material suitable for cleaning eyeglasses.
Power Connector
1. Remove the battery from RS6000.
2. Dip the cotton portion of the cotton tipped applicator in isopropyl alcohol.
3. Rub the cotton portion of the cotton tipped applicator back-and-forth across the battery connector inside the
battery compartment and the I/O connector on the top side of the RS6000. Do not leave any cotton residue on
the connectors.
4. Repeat at least three times.
5. Use the cotton tipped applicator dipped in alcohol to remove any grease and dirt near the connector area.
6. Use a dry cotton tipped applicator and repeat steps 3 through 5.
7. Spray compressed air on the connector area by pointing the tube/nozzle about ½ inch away from the surface.
8. Inspect the area for any grease or dirt, repeat if required.
CAUTION: Do not pour, spray, or spill any liquid on the RS6000.
CAUTION: Do not point nozzle at yourself and others, ensure the nozzle or tube is away from your face.
To Next Page
Loading...
Need help?
General
