Bluetooth Communications
59
Variable PIN Code
Parameter # 608
When connecting to a host device with authentication enabled, scan Static PIN Code below to avoid entering the
PIN code manually. The PIN stored in memory is used. Scan the Variable PIN Code below to manually enter a
PIN code with each connection.
The default PIN code is the user-programmed PIN set and stored above. Typically, however, HID connections
require entering a Variable PIN Code. If, when attempting connection, the application presents a text box that
includes a PIN, scan the Variable PIN Code bar code, then re-attempt connection. When you hear a beep
indicating the RS6000 is waiting for an alphanumeric entry, enter the provided variable PIN using the Alphanumeric
and Numeric Bar Codes on page 323, then scan End of Message on page 331 if the code is less than 16
characters. The RS6000 discards the variable PIN code after connection.
*Static PIN Code
(0)
Variable PIN Code
(1)
To Next Page
Loading...
Need help?
General
