Bluetooth Communications
67
Reconnect Attempt Beep Feedback
Parameter # 559
When the RS6000 disconnects as it goes out of range, it immediately attempts to reconnect. While the RS6000
attempts to reconnect, the Status LED continues to blink blue. If the auto-reconnect process fails, the RS6000
emits a page timeout beep (long low/long high) and the Status LED stops blinking. The process can be restarted by
pulling the trigger or pressing the restore key.
The Beep on Reconnect Attempt feature is disabled by default. When enabled, the RS6000 emits five short high
beeps every five seconds while the re-connection attempt is in progress. Scan a bar code below to enable or
disable Beep on Reconnect Attempt.
*Disable Beep on Reconnect Attempt
(0)
Enable Beep on Reconnect Attempt
(1)
To Next Page
Loading...
Need help?
General
