Symbologies
186
Code 93
Enable/Disable Code 93
Parameter # 9 (SSI # 09h)
To enable or disable Code 93, scan the appropriate bar code below.
Set Lengths for Code 93
Parameter # L1 = 26 (SSI # 1Ah), L2 = 27 (SSI # 1Bh)
The length of a code refers to the number of characters (i.e., human readable characters), including check digit(s)
the code contains. Set lengths for Code 93 to any length, one or two discrete lengths, or lengths within a specific
range. The default is 1 to 55.
• One Discrete Length - Select this option to decode only Code 93 symbols containing a selected length.
Select the length using the numeric bar codes in Alphanumeric and Numeric Bar Codes. For example, to
decode only Code 93 symbols with 14 characters, scan Code 93 - One Discrete Length, then scan 1
followed by 4. To correct an error or to change the selection, scan Cancel on page 324.
• Two Discrete Lengths - Select this option to decode only Code 93 symbols containing either of two
selected lengths. Select lengths using the numeric bar codes in Alphanumeric and Numeric Bar Codes.
For example, to decode only Code 93 symbols containing either 2 or 14 characters, select Code 93 - Two
Discrete Lengths, then scan 0, 2, 1, and then 4. To correct an error or to change the selection,
scan Cancel on page 324.
• Length Within Range - Select this option to decode a Code 93 symbol with a specific length range.
Select lengths using the numeric bar codes in Alphanumeric and Numeric Bar Codes. For example, to
decode Code 93 symbols containing between 4 and 12 characters, first scan Code 93 - Length Within
Range. Then scan 0, 4, 1, and 2 (enter a leading zero for single digit numbers). To correct an error or
change the selection, scan Cancel on page 324.
• Any Length - Scan this option to decode Code 93 symbols containing any number of characters within the
RS6000’s capability.
*Enable Code 93
(1)
Disable Code 93
(0)
To Next Page
Loading...
Need help?
General
