Bluetooth Communications
77
Auto Un-Pairing
Parameter # 1708
The auto un-pair parameter configures the RS6000 to un-pair from the host computer on specific events.
• Disable (default) - the RS6000 will not auto un-pair on any events.
• On cradle insertion - the RS6000 will un-pair when inserted charging cradle
• On reset - the RS6000 will un-pair if a warm or cold reset occurs
• On cradle or reset - the RS6000 will un-pair on cradle insertion or reset event.
*Disable
Un-pair on Cradle Insertion
On Reset
On Cradle or Reset
To Next Page
Loading...
Need help?
General
