Accessories
85
Figure 32 Insert Battery into Cradle
2. Ensure the battery is seated properly. The Spare Battery Charging LED blinks indicating charging.
Battery Charging
The RS6000 Charging LED indicates the charging status of the battery in the RS6000 and the Spare Battery
Charging LED indicates the charging status of the spare battery. See Table 7 on page 85. The 3,350 mAh battery
fully charges in less than four hours at room temperature.
Charge batteries in temperatures from 0 °C to 40 °C (32 °F to 104 °F). The device and cradle monitor the battery
temperature. Battery charging is only performed when the battery is within safe charging temperature limits. At
higher temperatures (e.g. approximately +35 °C (+95 °F)) the device or charging cradle may for small periods of
time alternately enable and disable battery charging to keep the battery at acceptable temperatures. This process
may require additional time to complete a full charge cycle. The cradle indicates when charging is disabled due to
abnormal temperatures via the Status LED.
Table 7 Charging LED Indicators
State Indication
Off The battery is not charging. The battery is not inserted correctly in the cradle or
connected to a power source. Cradle is not powered.
Solid Amber Battery is charging.
Solid Green Battery charging is complete.
Fast Blinking Red
(2 blinks/second)
Charging error, e.g.:
- Temperature is too low or too high.
- Charging has gone on too long without completion (typically eight hours).
Solid Red Unhealthy battery is charging or fully charged.
To Next Page
Loading...
Need help?
General
